Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Idle Tracking Switch
Idle tracking switch, located on carburetor, is a mechanically operated electric switch held open by throttle linkage when throttle is closed and is used on Extended Idle Air By-Pass System.
When idle tracking switch is opened, EEC Module is signaled to de-energize normally closed solenoid. When this happens, vacuum is removed from normally closed by-pass valve and causes thermactor air to be dumped into atmosphere.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.