Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1982LYNX LS, 4D HATCHBACK, AUTOMATIC TRANSREPAIR AND DIAGNOSISELECTRICALSTARTERSTARTER REMOVAL PROCEDURES - ALL MODELSGENERAL MOTORSBUICK4.3L (262") V6 DIESEL FRONT WHEEL DRIVE
1982 Mercury Lynx LS, 4D Hatchback, Automatic Trans
4.3L (262") V6 Diesel Front Wheel Drive
1982 Mercury Lynx LS, 4D Hatchback, Automatic TransSECTION 4.3L (262") V6 Diesel Front Wheel Drive
- Disconnect negative battery cable at battery. Install engine support fixture (J-22825-45, J-22825-1, and J22825-48) as shown in Figure . Raise vehicle on hoist.
- Remove left and center engine mount stud nuts. Remove 2 front cradle mount bolts. Lower cradle. Remove 4 flywheel cover bolts. Remove flywheel cover (2 pieces).
- Remove starter shield nut at starter. Remove flex shield. Disconnect wires from starter. Remove 2 starter bolts. Remove starter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.