SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1982COLONY PARK V8-302 5.0L VIN F 2-BBLREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRREAR DOOR WINDOW SWITCH
1982 Mercury Colony Park V8-302 5.0L VIN F 2-bbl

Rear Door Window Switch

1982 Mercury Colony Park V8-302 5.0L VIN F 2-bblSECTION Rear Door Window Switch


Removal and Installation

There are 2 styles of Rear Door Window Switches, a door panel mounted and an armrest mounted. The door panel mounted is shown below. For armrest mounted, please refer to RH Front Door Window Switch procedure. RH Front Door Window Switch

Figure 8 - Power Window Switches:






1. Remove switch bezel retaining screw from the bottom side of the bezel.
Pivot the lower edge of the bezel out and up to remove the bezel.
2. The switch is held in place by the electrical contact pins.
To remove the switch, carefully pry the switch from the connector with a small screwdriver.
3. To install, position switch to connector and press firmly into place.
4. Install the bezel on the door trim panel and install the bezel retaining screw.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.