SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1975COUGAR 5.8L ENG VIN HREPAIR AND DIAGNOSISSUSPENSIONSUSPENSION CONTROL SYSTEMSAUTOMATIC LEVEL CONTROLTESTING & ADJUSTMENTHEIGHT CONTROL VALVEFUNCTION TESTING
1975 Mercury Cougar 5.8L Eng VIN H

Function Testing

1975 Mercury Cougar 5.8L Eng VIN HSECTION Function Testing
  1. Disconnect overtravel lever from link. Exhaust air from shocks by holding lever down until air sleeves deflate. Start engine and run at idle. Pressurize system with external source to 90 psi. Hold lever down in exhaust position until sleeves deflate. If sleeves do not deflate, remove exhaust adaptor from control valve and hold lever down to deflate sleeves. If sleeves now deflate, replace adaptor, "O" ring, and filter. If defective condition is not corrected by these replacements, replace height control valve.
  2. Hold lever up in intake position until sleeves inflate. If sleeves inflate and hold, proceed to TIME DELAY TEST . If sleeves inflate, then leak down, check lines, fittings, and sleeves for air leaks. If sleeves still do not inflate, perform LEAK TEST .
    Fig 1: Automatic Air Leveling System
    G09349120Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.