Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Cylinder: Installation
Install washer, sleeve and insulator on end of power cylinder rod. Extend rod as far as possible. Insert rod in bracket on frame and compress rod as necessary to insert stud in center link. Secure stud with a castellated nut and cotter pin. Secure power cylinder rod with an insulator, washer, nut and a pal nut. Connect fluid lines to their respective ports in the cylinder. Fill reservoir to correct level.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.