Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1966CAPRI NOT AVAILABLE, 3.3L ENG VIN TREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETUNE-UPTUNE-UP - 6 CYLENGINE IDENTIFICATIONVALVE TAPPET CLEARANCE
1966 Mercury Capri Not Available, 3.3L Eng VIN T
Valve Tappet Clearance
1966 Mercury Capri Not Available, 3.3L Eng VIN TSECTION Valve Tappet Clearance
Zero lash (hydraulic), used on all engines. With lifter fully collapsed, clearance between rocker arm and valve stem tip should be.066-.216" (170", 200").
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.