Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ2025SPRINTER 3500XD 2D CAB CHASSIS EXTENDED, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 50 (COMPUTER RELEARN PROCEDURES)RELEARN PROCEDURESREMOTE KEYLESS ENTRY (RKE) TRANSMITTER PROGRAMMINGCONTINENTAL
2025 Mercedes Benz Sprinter 3500XD 2D Cab Chassis Extended, RWD
Remote Keyless Entry (RKE) Transmitter Programming: Continental
2025 Mercedes Benz Sprinter 3500XD 2D Cab Chassis Extended, RWDSECTION Continental
WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Sable, 2000 Mercury Mystique, 2000 Mercury Mountaineer, and 2000 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
- Enter 5-digit permanent entry code at keypad. Within 5 seconds of pressing last digit, press 1/2 button on keypad. Hold 1/2 button for more than 2 seconds to erase all stored customer codes. Door locks will lock and unlock to confirm all codes are erased. Existing codes do not need to be erased to program new codes.
- Press and hold any button on remote transmitter within 5 seconds of pressing 1/2 button. Doors will lock and unlock to confirm programming. Driver door module will automatically associate remote transmitters to a personality setting. The first remote transmitter to be programmed will be position No. 1, and the second remote transmitter will be position No. 2. Remaining remote transmitters, if programmed, will not be associated to a personality setting.
- If additional remote transmitters are to be programmed, press any button on next remote transmitter to be programmed within 7.5 seconds of pressing button on last transmitter. If programming is successful, doors will signal by locking and unlocking.
- After all remote transmitters are programmed, a new keyless entry keypad code can be programmed within 7.5 seconds of pressing button on last remote transmitter. To exit program mode, press keyless entry keypad buttons 7/8 and 9/0 at the same time or wait 7.5 seconds for DDM to exit automatically.
NOTE:
To enter programming mode, ensure battery is fully charged and anti-theft system (if equipped) is not armed or triggered. Up to 4 transmitters may be programmed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.