Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ2025SPRINTER 3500XD 2D CAB CHASSIS EXTENDED, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 470 (MODULE CONFIGURATION)GENERAL PROCEDURESPROGRAMMABLE MODULE INSTALLATIONUSING THE WORLDWIDE DIAGNOSTIC SYSTEM (WDS) WHEN THE ORIGINAL BODY CHASSIS ELECTRICAL MODULE IS NOT AVAILABLE
2025 Mercedes Benz Sprinter 3500XD 2D Cab Chassis Extended, RWD
Using The Worldwide Diagnostic System (WDS) When The Original Body Chassis Electrical Module Is Not Available
2025 Mercedes Benz Sprinter 3500XD 2D Cab Chassis Extended, RWDSECTION Using The Worldwide Diagnostic System (WDS) When The Original Body Chassis Electrical Module Is Not Available
WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new module.
- Connect the WDS and ID the vehicle as normal.
- From the Toolbox icon, select and highlight: Module Programming and then highlight the module that was installed and press the check mark.
- Select and highlight: Programmable Module Installation and then highlight the module that was installed then press the check mark.
- Follow the on-screen instructions and turn the ignition key to the OFF position and press the check mark.
- The WDS will retrieve the module data from the PCM and automatically download the data into the new module and display Module Configuration Complete.
- If the data is not available in the PCM, the WDS will display a screen stating to contact the As-Built Data Center.
- Enter the module data.
- WDS will download the data into the new module and display.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.