SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ2025SPRINTER 3500XD 2D CAB CHASSIS EXTENDED, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1919 (ENGINE - 2.3L - (HYBRID))IN-VEHICLE SERVICINGTIMING DRIVE COMPONENTSINSTALLATION
2025 Mercedes Benz Sprinter 3500XD 2D Cab Chassis Extended, RWD

Timing Drive Components: Installation

2025 Mercedes Benz Sprinter 3500XD 2D Cab Chassis Extended, RWDSECTION Installation
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the camshaft sprockets and the bolts. Do not tighten the bolts at this time.
    2. Fig 1: Locating Camshaft Sprocket Bolts
    G03897782Courtesy of FORD MOTOR CO.
  2. Install the LH timing chain guide and the bolts.
    • Tighten to 10 Nm (89 lb-in).
    3. Fig 2: Identifying Bolts And LH Timing Chain Guide
    G03897780Courtesy of FORD MOTOR CO.
  3. Install the timing chain.
    4. Fig 3: View Of Timing Chain
    G03897779Courtesy of FORD MOTOR CO.
  4. Install the RH timing chain guide.
    5. Fig 4: Locating RH Timing Chain Guide
    G03897778Courtesy of FORD MOTOR CO.
  5. Install the timing chain tensioner and the bolts. Remove the paper clip to release the piston.
    • Tighten to 10 Nm (89 lb-in).
    6. Fig 5: Locating Timing Chain Tensioner Bolts And Paper Clip
    GF0024080Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.