Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ2006E500 BASEREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDTC INDEX - 211 CHASSISBODY CONTROL MODULE DTCS2003-07
2006 Mercedes Benz E500 Base
Body Control Module DTCS: 2003-07
2006 Mercedes Benz E500 BaseSECTION 2003-07
BODY CONTROL DIAGNOSTIC TROUBLE CODE LIST
| DTC | TEST/REMEDY |
|---|---|
| D004 | Audio gateway (AGW) shuts down caused by too much heat; a fault code may also be stored |
| 9386 | DTC stored in system diagnosis |
| D300 | Fault code stored in navigation system |
DIAGNOSTIC TROUBLE CODE LIST
| DTC | TEST/REMEDY |
|---|---|
| 9050 | Error message in instrument cluster in red lettering at high outside temperatures and faults codes are stored in battery control unit |
| 9051 | Error message in instrument cluster in red lettering at high outside temperatures and faults codes are stored in battery control unit |
| B9070 | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B9071 | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B9078 | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B9079 | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B906C | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B906D | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B906F | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B907A | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| B907AB | SRS indicator lamp comes on and DTCs are stored in restraint system control module |
| 9000 | DISPLAY SYMBOL "BATTERY" AND FAULT MESSAGE "LOCATE WORKSHOP" shortly after engine start, fault code stored in battery control unit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.