Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Map-based position finding, function - GF82.61-P-3008R
MODELS 203.0 /2 /7 up to 23.4.04 with CODE (352a) COMAND operating and display system with CODE (491) U.S. version
Map-supported map matching
Function
Map-based position finding is only available in the digitized area of the Compact Disk (CD) map. By comparing the calculated position of the vehicle with the CD map, the deviation can be detected and automatically corrected.
The position of the vehicle is followed continuously on the CD map by the navigation processor of the COMAND operating, display and control unit (A40/3). In the event of deviations from the calculated route during a journey, the basic position finding position coordinates will be corrected if necessary.
| Operating, display and control unit, location/ task/design/function | GF82.85-P-3114R | ||
| Basic position finding, function | GF82.61-P-3006R | ||
| Global positioning system (GPS) position finding, function | GF82.61-P-3007R | ||
| Destination guidance, function | GF82.61-P-3012R |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.