Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE
Fuel System -- 208 Chassis
- Basic Knowledge
- Fuel tank position/design/function - GF47.10-P-3000E
- On-board refueling vapor recovery function - GF47.10-P-3004B
- Drain valve position/task/design/function - GF47.10-P-3100H
- Splash bowl position/task/function - GF47.10-P-3101E
- Suction spray pump position/task/design/function - GF47.10-P-3102E
- Blanking plate position/task/design - GF47.10-P-3103H
- Fuel pump assembly overview - GF47.20-P-0025-02A
- Purge system with leak test function - GF47.30-P-3016L
- Activated charcoal canister location/task/design/function - GF47.30-P-3102F
- Purge control valve, location/task/design/function - GF47.30-P-4030L
- Fuel tank pressure sensor location/task/function - GF47.30-P-4032L
- Activated charcoal canister shutoff valve location/task/design/ function - GF47.30-P-4033L
- Safety Precautions
- Testing & Repair
- Testing and repair work: Passenger cars: Fuel system - AR47.00-Z-9112AB
- Testing and repair work: Passenger cars: Fuel system - AR47.00-Z-9113AB
- Testing and repair work: Passenger cars: Fuel system - AR47.00-Z-9208AA
- Draining and filling fuel tank - AR47.10-P-4001E
- Remove/install fuel tank - AR47.10-P-4100E
- Remove, install fuel gage sensor - AR47.10-P-7000E
- Removing and installing guide funnel - AR47.10-P-7571D
- Removing and installing expansion reservoir - AR47.10-P-8021F
- Removing, installing fuel pump - AR47.20-P-5710AV
- Removing and installing activated charcoal canister - AR47.30-P-8212
- Removing, installing shutoff valve - AR47.31-P-8023D
- Maintenance
- Component Modifications
- Miscellaneous Notes
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
