Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
General Information On Chassis Alignment
- Check condition of tires.
- Check condition of rims.
- Check tire inflation pressure, refer to table with tire inflation pressures in the fuel filler door and correct the pressures as required.
- Check vehicle underbody.
- Inspect wheel bearing play (without dial gauge).
- Check condition of steering mechanism.
- Check condition of rubber boot.
- Check overall condition of vehicle.
- The vehicle should be checked and adjusted in "ready-to-drive condition". See RIDING HEIGHT ADJUSTMENTS .
- Check alignment of vehicle, see PERFORMING CHASSIS ALIGNMENT CHECK .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.