Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ1993400EREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESSAABSYSTEM OPERATION CHECK900 SERIES
1993 Mercedes Benz 400E
900 Series
1993 Mercedes Benz 400ESECTION 900 Series
- Turn ignition on. SRS warning lights should come on for 3-4 seconds, then go out. If light remains on, or does not come on at all, a fault exists in system.
- If, a fault occurs in system while ignition is on, SRS warning light will flash for about 5 minutes and then stay lit. On vehicles equipped with a central warning light, if air bag is deployed, SRS warning light will flash for about 5 seconds and then stay lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.