Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ1993400EREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSREMOVAL & INSTALLATIONHEADLIGHT WIPER SYSTEMREMOVAL
1993 Mercedes Benz 400E
Headlight Wiper System: Removal
1993 Mercedes Benz 400ESECTION Removal
- Disconnect headlight wiper motor harness connector in engine compartment. Pull harness and connector through rubber grommet from wheelwell side. Disconnect washer hose from "T" fitting behind bumper.
- Pivot wiper arms outward at pivot base to access mounting nuts. Remove nuts and wiper arms. If equipped, loosen oil reservoir on vehicles equipped with level control system.
- Remove wiper motor bracket mounting bolts. Remove motor assembly by gently pulling drive system through front body panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.