Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Mazda CX-50 SFACTORY OEM SERVICE PROCEDURE
PID/DATA Monitor Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Access and monitor the PID/DATA monitor item EX_SHUT_VLV_ACT and simulation item EX_SHUT_VLV_DSD. (See PID/DATA MONITOR INSPECTION .) (See SIMULATION INSPECTION .)
- Verify that the EX_SHUT_VLV_ACT PID value increases linearly, while increasing the opening angle of the exhaust shutter valve using the active command mode function of EX_SHUT_VLV_DSD.
- If the EX_SHUT_VLV_ACT PID does not increase according to the exhaust shutter valve opening angle, inspect the exhaust shutter valve. (See EXHAUST SHUTTER VALVE INSPECTION .)
- If the EX_SHUT_VLV_ACT PID increases increase linearly according to the exhaust shutter valve opening angle, the exhaust shutter valve is normal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.