Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2023CX-5 SREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSALL WHEEL DRIVE - SERVICE INFORMATIONAWD CONTROL MODULE INSPECTIONNOTES
2023 Mazda CX-5 S
AWD Control Module Inspection: Notes
2023 Mazda CX-5 SSECTION Notes
NOTE:
- AWD Control Module terminal voltage can vary depending on measuring conditions and vehicle aging, resulting in misdiagnosis. Therefore, it is necessary to perform an overall inspection of the input/output systems and AWD Control Module to determine which part is malfunctioning.
- With the AWD Control Module connector connected, measure voltage by connecting the voltmeter negative (-) lead to the body ground and positive (+) lead to each AWD Control Module terminal.
- Measure voltage or resistance at each AWD Control Module terminal using a voltmeter and an ohmmeter.
- If not as specified, replace the AWD Control Module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.