Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Gear And Linkage Assembly: Notes
2023 Mazda CX-5 SSECTION Notes
Special Service Tool (SST)
| 49 JP02 001 Adjustable wrench |
49 T025 001 Boot clamp crimpers |
Replacement Part
| Boot band |
| Quantity: 2 |
| Location of use: Boot |
Oil and Chemical Type
| Grease |
| Type: MOLYWHITE LSG |
CAUTION:
- To prevent damage to the steering gear, secure it to the vise using a copper plate or clean cloth.
- Assemble in the order shown in the figure.
- Install the steering gear and linkage. (See STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION .)
Courtesy of MAZDA MOTORS CORP.
STEERING GEAR AND LINKAGE ASSEMBLY COMPONENT OPERATIONSComponent No. Refer to 1 Steering gear 2 Tie Rod
(See Tie Rod Assembly Note .)3 Boot 4 Boot band
(See Boot Band Assembly Note .)5 Boot clamp 6 Locknut 7 Tie-rod end
(See Tie-rod End Assembly Note .)8 Dust cover
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.