Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
EPS Control Module Inspection: Notes
2023 Mazda CX-5 SSECTION Notes
- Remove the driver-side front scuff plate. (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Remove the driver-side front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Remove the lower decoration panel. (See DECORATION PANEL REMOVAL/INSTALLATION .)
- Remove the hood release lever. (See HOOD RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION .)
- Remove the fuel-filler lid opener lever. (See FUEL-FILLER LID OPENER CABLE REMOVAL/INSTALLATION .)
- Remove the driver-side lower panel. (See LOWER PANEL REMOVAL/INSTALLATION .)
- Attach the tester lead to the underside of the EPS Control Module connector and inspect the voltage according to the terminal voltage table (reference).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.