SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2023CX-5 SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (ENGINE MECHANICAL SYSTEM)TIMING CHAIN REMOVAL/INSTALLATIONTIMING CHAIN REMOVAL NOTE
2023 Mazda CX-5 S

Timing Chain Removal Note

2023 Mazda CX-5 SSECTION Timing Chain Removal Note
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate the crankshaft clockwise to align the timing marks and the key position as shown in the figure, and set cylinder No. 1 at top dead center (TDC).
    Fig 1: Aligning Timing Marks And Key Position
    G10915973Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.