SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2023CX-5 SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 201 (SECURITY AND LOCKS)START STOP UNIT INSPECTIONNOTES
2023 Mazda CX-5 S

Start Stop Unit Inspection: Notes

2023 Mazda CX-5 SSECTION Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Because the start stop unit terminals 3A-3L and 4A-4L are inside the start stop unit and not exposed, the terminal voltage cannot be measured.
  • Terminals with terminal voltage that cannot be measured are not indicated in the terminal voltage table (reference).
  1. Remove the following parts:
    1. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
  2. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
    • If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
      • If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the start stop unit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.