SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2023CX-5 SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 200 (ON-BOARD DIAGNOSTIC - REAR BODY CONTROL MODULE (RBCM))DTC B1207-09; ERROR SIGNAL RECEIVED FROM SAS CONTROL MODULENOTES
2023 Mazda CX-5 S

DTC B1207-09; Error Signal Received From SAS Control Module: Notes

2023 Mazda CX-5 SSECTION Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE

Description Error signal received from SAS control module
Detection condition
  • The rear body control module (RBCM) detected the following conditions for 3 s or more with the ignition switched ON (engine off or on).
    • A signal is received which cannot normally determine the collision conditions from SAS control module even though the collision detection unlock function presence signal received from the rear body control module (RBCM) determines that the function is present.
Fail-safe Not applicable
Possible cause
  • DTCs are stored in the SAS control module.
  • SAS control module malfunction
System wiring diagram Not applicable
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.