2020 Mazda 3 Base, 4D Hatchback, AWDFACTORY OEM SERVICE PROCEDURE

Simulation Table (Us)

-: Not applicable

SIMULATION REFERENCE (US)

Simulation item Unit/Condition Operation Operation condition
Engine condition Other condition
A/C_REQ No(False)/Yes(True)
  • Select No/Yes to forcibly change the A/C switch status.
  • Under the following conditions Idle (no load)
  • Not applicable
A/C_SW Off/On
  • Select Off/On to disengage/engage the magnetic clutch.
  • Under the following conditions Idle (no load)
  • Not applicable
AIRSH UT_POS_COMD (2) % Open
  • Changes % to forcibly open/close the active air shutter.
  • Not applicable
  • Not applicable
CHARGE_LAMP No(False)/Yes(True)
  • Select No/Yes to turn on/off the charging system warning light.
  • Select No/Yes to display/not display the charging system warning indication on the multi-information display.
  • Under the following conditions
    • Ignition is switched ON (engine off)
    • Idle
      • Racing (not idle)
  • Not applicable
CSTR_VENT_SOL_DUTY (1) %
  • Changes % and forcibly drives/stops CV solenoid valve.
  • Under the following conditions
    • Ignition is switched ON (engine off)
    • Idle
      • Racing (not idle)
 
CAUTION:
  • Do not add fuel with the CV solenoid valve closed.

Otherwise, it will result in air pollution because the evaporative gas in the fuel tank will escape directly into the atmosphere.
NOTE:
  • Override drive parameter: 0%
    • CV solenoid valve: open
  • Override drive parameter: 100%
    • CV solenoid valve: close
EGR_COMD %
  • Displays in the M-MDS but it does not operate.
ENG_COOL_VLV_POS_COM D °(deg)
  • Changes °(deg) and forcibly drives/stops coolant control valve.
  • Under the following conditions:
    • Ignition is switched ON (engine off)
 
NOTE:
  • Override drive parameter: 0%119°
ENG_RPM_DSD Rpm
  • Changes value (RPM) to forcibly vary engine speed.
  • Under the following conditions:
    • Idle
      • Racing (not idle)
  • The use in the following ranges is recommended:
    • Engine coolant temperature: 75-95 °C {167-203 °F}
    • Vehicle speed: 0 km/h {0 mph}
      • Override drive parameter input range: 550-2, 000 RPM
FAN %
  • Displays in the M-MDS but it does not operate.
FP_DUTY %
  • Changes % and forcibly drives/stops fuel pump.
  • Under the following conditions:
    • Ignition is switched ON (engine off)
    • Idle
      • Racing (not idle)
 
WARNING:
  • Do not use the simulation function while the fuel hose between the high pressure fuel pump and fuel pump is removed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.