Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Mazda 3 Base, 4D Hatchback, AWDFACTORY OEM SERVICE PROCEDURE
On-Board Diagnostic - Engine (Introduction)
- Freeze Frame Data Table (Us)
- INAPPROPRIATE OPERATION AND CONTROL RECORD 0x30 (TEMPERATURE RESTRICTION CONTROL)
- INAPPROPRIATE OPERATION AND CONTROL RECORD 0x43 (UNUSUAL VOLTAGE OF A BATTERY)
- Inappropriate Operation And Control Record (Us)
- OBD-II Drive Mode (VIN M)
- OBD-II Drive Mode (VIN L)
- PID/Data Monitor Table (Us)
- Simulation Table (Us)
- Snapshot Data Table
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
