2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Fuel Injection Control (+) Signal

Fig 1: Fuel Injection Control (+) Output Voltage Signal Graph
G11436136Courtesy of MAZDA MOTORS CORP.

PCM terminals 

  • Fuel Injection No. 1: 1DP(+)-body ground(-)
  • Fuel Injection No. 2: 1DX(+)-body ground(-)
  • Fuel Injection No. 3: 1EB(+)-body ground(-)
  • Fuel Injection No. 4: 1DT(+)-body ground(-)

Oscilloscope setting 

  • 20 V/DIV (Y), 50 ms/DIV (X), DC range

Vehicle condition 

  • Idle after warm up
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.