2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Resistance Inspection

  1. Turn the steering wheel to full right lock.
  2. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  3. Lift up the vehicle.
  4. Remove the front splash shield (RH). (See SPLASH SHIELD REMOVAL/INSTALLATION .)
  5. Disconnect the engine oil pressure sensor/engine oil temperature sensor connector. (See ENGINE OIL PRESSURE SENSOR/ENGINE OIL TEMPERATURE SENSOR REMOVAL/INSTALLATION (VIN Y) .)
  6. Measure the resistance between engine oil pressure sensor/engine oil temperature sensor terminals E and C.
    Fig 1: Engine Oil Temperature Sensor Connector Terminals
    G12232016Courtesy of MAZDA MOTORS CORP.

Specification (Reference) 

RESISTANCE SPECIFICATION

Engine Oil Temperature (°C {°F}) Resistance (Kilohms)
-40 {-40} Approx. 44.9
0 {32} Approx. 5.78
25 {77} Approx. 2.04
140 {284} Approx. 0.0719
Fig 2: Engine Oil Temperature Resistance Graph
G11436098Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.