Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
PID/DATA Monitor Inspection
- Verify that there is no engine oil leakage.
- If there is any malfunction, repair or replace the malfunctioning part according to the inspection results.
- Inspect the engine oil level. (See ENGINE OIL LEVEL INSPECTION (VIN Y) .)
- Switch the ignition ON (engine off).
- Access the PID/DATA monitor item OIL_LEVEL using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST (VIN Y) .)
- Verify that the PID OIL_LEVEL value and the engine oil amount measured using the dipstick are same.
Courtesy of MAZDA MOTORS CORP.
Engine oil level sensor output value (Reference)Β
ENGINE OIL LEVEL SENSOR OUTPUT VALUE REFERENCEDipstick PID OIL_LEVEL value Close to MAX Approx. 72.3 mm {2.85 in} Close to MIN Approx. 54.3 mm {2.14 in} - If it cannot be verified, replace the engine oil level sensor. (See ENGINE OIL LEVEL SENSOR REMOVAL/INSTALLATION (VIN Y)Β .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
