2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Function Inspection

  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition ON (engine off).
  3. Display the PID INLET_PRES. (See ON-BOARD DIAGNOSTIC TEST (VIN Y) .) (See PCM INSPECTION (VIN Y) .)
  4. Compare the voltage and boost pressure indications for the PID INLET_PRESS with the standard in the table indicated below.
    • If they do not match the standard, perform the voltage inspection. (See Voltage Inspection .)

Standard 

VOLTAGE SPECIFICATION

INLET_PRESS Remarks
V kPa {kgf/cm2 , psi}
Approx. 4.12 101 {1.03, 14.6} Ignition switched ON (engine off)
Approx. 1.90 33 {0.34, 4.8} Idle (after warm up)
Approx. 1.23 26 {0.27, 3.8} Racing (Engine speed: 2, 000 rpm)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.