2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Function Inspection

  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition ON (engine off).
  3. Display the PID TP_UP_TEMP. (See ON-BOARD DIAGNOSTIC TEST (VIN Y) .) (See PCM INSPECTION (VIN Y) .)
  4. Compare the voltage and temperature indications for the PID TP_UP_TEMP with the standard in the table indicated below.

Standard 

PID TP-UP TEMPERATURE INDICATIONS

PIDTP_UP_TEMP
V °C {°F}
Approx. 3.57 20 {68}
Approx. 2.70 40 {104}
Approx. 1.87 60 {140}
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.