2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Barometric Pressure (BARO) Sensor Inspection

NOTE:
  • Because the BARO sensor is integrated in the PCM, replacing the BARO sensor includes replacement of the PCM.
  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition ON (engine off).
  3. Measure the barometric pressure using a barometer.
  4. Verify that the measured barometric pressure and the actually measured barometric pressure (PID: BARO) input from the BARO sensor match. (See ON-BOARD DIAGNOSTIC TEST (VIN Y) .) (See PCM INSPECTION (VIN Y)Β .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.