Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PID OIL_TEMP. (See ON-BOARD DIAGNOSTIC TEST .) (See PCM INSPECTION .)
- Compare the voltage and temperature indications for the PID OIL_TEMP with the standard in the table indicated below.
- If they do not match the standard, perform the resistance inspection. (See Resistance Inspection .)
Standard
PID OIL TEMPERATURE SPECIFICATION
| OIL_TEMP | |
|---|---|
| V | °C {°F} |
| Approx. 3.02 | Approx. 32 {89.6} |
| Approx. 1.1 | Approx. 94 {201.2} |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
