Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
Resistance Inspection
- Turn the steering wheel to full right lock.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Lift up the vehicle.
- Remove the front splash shield (RH). (See SPLASH SHIELD REMOVAL/INSTALLATION .)
- Disconnect the engine oil pressure sensor/engine oil temperature sensor connector. (See ENGINE OIL PRESSURE SENSOR/ENGINE OIL TEMPERATURE SENSOR REMOVAL/INSTALLATION .)
- Measure the resistance between engine oil pressure sensor/engine oil temperature sensor terminals E and C.
- If not as specified, replace the engine oil pressure sensor/engine oil temperature sensor. (See ENGINE OIL PRESSURE SENSOR/ENGINE OIL TEMPERATURE SENSOR REMOVAL/INSTALLATION .)
Specification (Reference)
RESISTANCE SPECIFICATION
| Engine Oil Temperature (°C {°F}) | Resistance (Kilohms) |
|---|---|
| -40 {-40} | Approx. 44.9 |
| 0 {32} | Approx. 5.78 |
| 25 {77} | Approx. 2.04 |
| 140 {284} | Approx. 0.0719 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
