2017 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Transaxle Range (Tr) Switch Removal/Installation: Notes

CAUTION:
  • Do not allow foreign material or water to penetrate the connector. Otherwise, it could cause poor contact and corrosion.
  1. Apply the parking brake firmly, and set the wheel blocks for both the front and rear wheels.
  2. Shift the selector lever to the N position.
  3. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  4. Disconnect the negative battery cable.
  5. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.5] .)
  6. Remove in the order shown in the figure.
  7. Install in the reverse order of removal.
  8. Inspect the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION .)
    Fig 1: Transaxle Range Switch Components With Torque Specification
    G13727511Courtesy of MAZDA MOTORS CORP.
    PART DESCRIPTION

    1 Connector
    2 Clip
    3 Selector cable
    4 Manual shaft nut
    (See MANUAL SHAFT NUT REMOVAL NOTE .)
    (See MANUAL SHAFT NUT INSTALLATION NOTE .)
    5 Washer
    6 Manual shaft lever
    7 TR switch
    (See TR SWITCH INSTALLATION NOTE .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.