2017 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

TR Switch Installation Note

  1. Verify that the manual shaft is in the N position.
    G13727513Courtesy of MAZDA MOTORS CORP.
  2. Adjust the TR switch so that the resistance between TR switch terminals B and C is 713-787 ohms.
    G13727514Courtesy of MAZDA MOTORS CORP.
  3. Tighten the TR switch installation bolts.

    Tightening torque 

    8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.