Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE
Fuel Pump Operation Inspection
- Remove the fuel-filler cap.
- Switch the ignition to ON.
- Turn the fuel pump relay from off to on using the FP PID and inspect if the operation sound is heard.
- If no operation sounds is heard, proceed to next step.
- Measure the voltage at wiring harness side fuel pump connector terminal B.
Specification
- B+ (Ignition at on)
- If the voltage is as specified, inspect the following:
- Fuel pump continuity
- Fuel pump GND
- Wiring harness between fuel pump relay terminal E and PCM terminal 1BG
- If not as specified, inspect the following:
- Fuel pump relay (See RELAY INSPECTION .)
- Wiring harness connector (Battery-Fuel pump relay-Fuel pump)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
