2014 Mazda 5 TouringFACTORY OEM SERVICE PROCEDURE

Load Compensation Inspection

  1. Start the engine and idle it.
  2. Connect the M-MDS to the DLC-2.
  3. Verify that P0506:00 or P0507:00 is not displayed.
  4. Access the RPM PID. (See ON-BOARD DIAGNOSTIC TEST .)
    NOTE:
    • Excludes temporary idle speed drop just after the loads are turned on.
  5. Verify that the engine speed is within the specification under each load condition.

    Idle-up speed (MTX: Neutral position, ATX: P, N position)Β 

    • A/C on: 600-800 rpm (MTX), 600-830 rpm (ATX)
    • Electrical loads on: 650-770 rpm (MTX), 600-770 rpm (ATX)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.