Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSISMAINTENANCEPROCEDURESGENERAL INFORMATIONUNITSNOTES
2013 Mazda MX-5 Miata Grand Touring, Automatic Trans
General Information: Units: Notes
2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Notes
UNITS CHART
| Electric current | A (ampere) | Torque | N.m (Newton meter) |
| Electric power | W (watt) | kgf.m (kilogram force meter) | |
| Electric resistance | ohm | kgf.cm (kilogram force centimeter) | |
| Electric voltage | V (volt) | ft.lbf (foot pound force) | |
| Length | mm (millimeter) | in.lbf (inch pound force) | |
| in (inch) | Volume | L (liter) | |
| Negative pressure | kPa (kilo pascal) | US gal (U.S. gallon) | |
| mmHg (millimeters of mercury) | US qt (U.S. quart) | ||
| inHg (inches of mercury) | Imp gal (Imperial gallon) | ||
| Positive pressure | kPa (kilo pascal) | Imp qt (Imperial quart) | |
| kgf/cm2 (kilogram force per square centimeter) | ml (milliliter) | ||
| cc (cubic centimeter) | |||
| cu in (cubic inch) | |||
| psi (pounds per square inch) | fl oz (fluid ounce) | ||
| Number of revolutions | RPM (revolutions per minute) | Weight | N (newton) |
| g (gram) | |||
| oz (ounce) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.