Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMSYMPTOM TROUBLESHOOTING [ENGINE CONTROL SYSTEM LF 2.0L]ENGINE CONTROL SYSTEM OPERATION INSPECTION [LF]MAIN RELAY OPERATION INSPECTION
2013 Mazda MX-5 Miata Grand Touring, Automatic Trans
Main Relay Operation Inspection
2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Main Relay Operation Inspection
- Verify that the main relay clicks when the ignition switch is turned to ON position and off.
- If there is no operation sound, inspect the following:
- Main relay (See RELAY INSPECTION ).
- Harness and connector between battery and main relay terminal E
- Harness and connector between PCM terminal 1Q and main relay terminal A
- If there is no operation sound, inspect the following:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.