Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSKNOCK SENSOR (KS) REMOVAL/INSTALLATION
2013 Mazda MX-5 Miata Grand Touring, Automatic Trans
Knock Sensor (KS) Removal/Installation
2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Knock Sensor (KS) Removal/Installation
- Remove the battery cover.
- Remove the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] ).
- Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION ).
- Disconnect the KS connector.
- Remove the KS installation bolt, then remove the KS.
- Install in the reverse order of removal.
KS tightening torque
16-24 N.m {1.7-2.4 kgf.m, 12-17 ft.lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.