Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENTATION/DRIVER INFOINSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODECHECK CODE INSPECTIONCHECK CODE 57
2013 Mazda MX-5 Miata Grand Touring, Automatic Trans
Check code 57
2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Check code 57
CODE INSPECTION CONDITION CHART
| Check code 57 | Panel light control signal | ||
|---|---|---|---|
| INSPECTION CONDITION | DISPLAY | ACTION | |
| Turn the headlight switch to the TNS position. After selecting check code 57, wait for approx. 2 s. |
on (FLASHING) | Illumination light (hazard warning switch, center panel module, etc). flashes three times. | The panel light control signal is normal. |
| Except above. | Verify that the voltage of instrument cluster terminal 1F is B+
.
|
||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.