Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMDSC SYSTEM INSPECTIONPREPARATION
2013 Mazda MX-5 Miata Grand Touring, Automatic Trans
DSC System Inspection: Preparation
2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Preparation
- Verify that battery is fully charged.
- Turn the ignition switch to the ON position, and verify that the ABS warning light goes out after approx. 3 s .
- Turn the ignition switch to the LOCK position.
- Jack up the vehicle and support it evenly on safety stands.
- Shift to the N position.
- Verify that all four wheels rotate.
- Rotate the inspected wheels by hand, and verify there is no brake drag.
- If there is any brake drag, perform regular brake inspection.
- If there is no brake drag, perform DSC HU/CM operation inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.