Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMTRUNK COMPARTMENT LIGHT BULB REMOVAL/INSTALLATION
2013 Mazda MX-5 Miata Grand Touring, Automatic Trans
Trunk Compartment Light Bulb Removal/Installation
2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Trunk Compartment Light Bulb Removal/Installation
- Remove the battery cover.
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] )
- Insert a tape-wrapped fastener remover into the service hole and pry with the screwdriver in the direction shown by the arrow (1) in the illustration to remove the trunk compartment light.
- Disconnect the trunk compartment light connector.
- Remove the trunk compartment light bulb.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.