Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2013MX-5 MIATA GRAND TOURING, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMFRONT FOG LIGHT BULB REMOVAL/INSTALLATION

2013 Mazda MX-5 Miata Grand Touring, Automatic Trans

Front Fog Light Bulb Removal/Installation

2013 Mazda MX-5 Miata Grand Touring, Automatic TransSECTION Front Fog Light Bulb Removal/Installation

Remove the battery cover.
Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] )
Remove the fasteners.
Slightly bend back the mudguard.

Fig 1: Mudguard Fasteners
Courtesy of MAZDA MOTORS CORP.
Disconnect the front fog light bulb connector.

Fig 2: Front Fog Light And Connector
Courtesy of MAZDA MOTORS CORP.
Rotate the front fog light bulb in the direction of the arrow shown in the illustration and remove it.
CAUTION:
- A halogen bulb generates extremely high heat when it is illuminated. If the surface of the bulb is soiled, excessive heat will build up and the life of the bulb will be shortened. When handling the bulb, hold the flange, not the glass. Wipe off any finger prints before installation.
Install in the reverse order of removal.

Fig 3: Front Fog Light Bulb

Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.