SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 I SV, 2.0L ENG VIN G, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 78 (COMPUTER RELEARN PROCEDURES)POWERTRAIN CONTROL MODULEPROGRAMMING PROCEDURE - TRIBUTEPOWERTRAIN CONTROL MODULE PROGRAMMING - WDS TESTER (PROCEDURE 1)
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic Trans

Powertrain Control Module Programming - WDS Tester (Procedure 1)

2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic TransSECTION Powertrain Control Module Programming - WDS Tester (Procedure 1)
WARNING: This page is about a different car, the 2003 Mazda Tribute, 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When PCM is replaced, NEW PCM must be programmed with old module's configuration information. Following step by step procedure guides you through replacement of PCM in a Tribute using WDS with B18 or later software. This procedure was performed using WDS B18 software. Later software versions may have a slightly different screen order or content.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.