Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 I SV, 2.0L ENG VIN G, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 134 (MODULE COMMUNICATIONS NETWORK)KEY PROGRAMMING USING TWO PROGRAMMED KEYSTO PROGRAM KEYS WITHOUT WDS OR WDS TESTER
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic Trans
To Program Keys Without WDS or WDS Tester
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic TransSECTION To Program Keys Without WDS or WDS Tester
WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- This procedure requires two previously programmed keys and at least one unprogrammed PATS key with correct key cut.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.