Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 I SV, 2.0L ENG VIN G, AUTOMATIC TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSPOWER WINDOW SYSTEM INITIALIZATION PROCEDURE
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic Trans
Power Window System Initialization Procedure
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic TransSECTION Power Window System Initialization Procedure
-
NOTE: If the following operations have been performed, initial setting is reset, and auto up/down and two-step down operation are disabled. Therefore, performing initial setting is necessary.
- Negative battery cable is disconnected.
- Power window main switch connector is disconnected.
- Power window system power supply fuse is removed.
- Switch the ignition to ON.
- Press the driver's seat switch to fully open the door glass.
- Pull up the driver's seat switch to the manual-up position to fully close the door glass and keep holding the switch up at the position for approx. 2 s .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.