Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 I SV, 2.0L ENG VIN G, AUTOMATIC TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEON-BOARD DIAGNOSTIC [BLIND SPOT MONITORING SYSTEM]ACTIVE COMMAND MODES TABLE [BLIND SPOT MONITORING (BSM)]BSM CONTROL MODULE (LH)
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic Trans
BSM Control Module (LH)
2013 Mazda 3 i SV, 2.0L Eng VIN G, Automatic TransSECTION BSM Control Module (LH)
| Command name | Unit/Operation | Operation condition | Output part name |
|---|---|---|---|
| VSPD | OFF/ON |
|
BSM control module (LH) |
| WRN_IND_L | Off/On |
|
BSM indicator light (LH) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.