Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSMANUAL TRANSAXLE CLUTCH [A26M-R]CLUTCH UNIT REMOVAL/INSTALLATIONPILOT BEARING INSTALLATION NOTE
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Pilot Bearing Installation Note
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Pilot Bearing Installation Note
- Use the SSTs to install the pilot bearing.
- As shown in the figure, press-fit the pilot bearing to the position which is 4.0-5.0 mm {0.16-0.19 in} from the crankshaft end.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.