Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSMANUAL TRANSAXLE (SERVICE, REMOVAL & INSTALLATION A26M-R)TRANSAXLE OIL REPLACEMENT
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Transaxle Oil Replacement
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Transaxle Oil Replacement
- Park the vehicle on level ground.
- Remove the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION .)
- Remove the drain plug and gasket.
- Drain the oil into a suitable container.
- Install a new gasket and the drain plug.
Tightening torque
- 28-51 N.m {2.9-5.2 kgf.m, 21-37 ft.lbf}
- Remove the oil level plug and gasket.
- Add the specified amount and type of oil through the oil level plug hole until the level reaches the bottom of the oil level plug hole.MANUAL TRANSAXLE OIL
Item Specification Grade API service GL-4 Viscosity SAE 75W-80 Capacity (approx. quantity) 2.4-2.6 L {2.6-2.7 US qt, 2.12-2.28 lmp qt} - Install a new gasket and the oil level plug.
Tightening torque
- 28-51 N.m {2.9-5.2 kgf.m, 21-37 ft.lbf}
- Install the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.