Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (AUTOMATIC TRANSAXLE (SERVICE, REMOVAL & INSTALLATION FS5A-EL))AUTOMATIC TRANSAXLE REMOVAL/INSTALLATIONTRANSAXLE INSTALLATION NOTE
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Transaxle Installation Note
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Transaxle Installation Note
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Verify that the torque converter stud bolts are inserted into the drive plate bolt holes, and install the transaxle installation bolts. Otherwise, the drive plate could be damaged.
- Verify that the torque converter stud bolts are inserted into the drive plate bolt holes from the starter installation hole.
- Install the transaxle mounting bolts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.